Setting TX Reports to Print Automatically (MF4370dn/MF4350d/D480 Only)

Article ID: ART129151 | Date published: 05/12/2015 | Date last updated: 08/17/2015


Setting TX Reports to Print Automatically (MF4370dn/MF4350d/D480 Only)


Setting the TX Reports to Print Automatically

This section describes how to set TX reports to print automatically.

The default setting is <PRINT ERROR ONLY>.

The following items are printed in a TX Report:

JOB NO.: Job number

MODE: Mode of transaction (G3 or ECM)

NO.: Sequence number

DESTINATION TEL/ID: Name and number of recipient

START TIME: Date and time of transaction

PAGE: Number of pages sent

RESULT: Result of transaction

  • OK: Transmission successful
  • NG: Transmission failed
  • STOP: Transmission manually canceled before completion
  • NO ANSWER: Call not answered
  • PAPER JAM: ADF jam occurs during Manual TX

1. Press [Menu].

2. Press [ ] or [ ] to select <REPORT SETTINGS>, then press [OK].

3. Press [ ] or [ ] to select <TX REPORT>, then press [OK].

4. Press [ ] or [ ] to select the setting you want, then press [OK].

  • <PRINT ERROR ONLY>: Prints a report only when a transmission error occurs.
  • <OUTPUT NO>: Does not print a report.
  • <OUTPUT YES>: Prints a report every time you send a document.

5. Press [Stop/Reset] to return to the standby mode.



Rate this Article
Was this article helpful?
Yes, This document is helpful
No, This document needs a clearer explanation
Please provide your comments