Select the new Access Point / Router to configure the connection (MP560, MP640, MP990)
Article ID: ART129439 | Date published: 05/12/2015 | Date last updated: 11/18/2015
 

Description

Select the new Access Point / Router to configure the connection (MP560, MP640, MP990)

Solution

Access Point / Router

The following information is required to connect to your access point or router. Once the information is obtained write it down for future reference.

Note: For details on how to check the following information, refer to the manual of your access point or router, or contact its manufacturer.

  • Access Point Name / Network Name (An identifier to identify the specific access point.)
    * Also referred to as SSID
  • Network Key
    * Also referred to as encryption key, WEP key or WPA/WPA2 passphrase, Pre-Shared key.
    A password is required to prevent unauthorized access to communication.
     

Important: An "Ad-hoc connection," which establishes a direct connection to the computer over wireless connection without using an access point, is not supported.

Be sure to prepare an access point.

 

  1. Use the Easy-Scroll Wheel (A) to select Settings, then press the <OK> button.



    The above illustration is a PIXMA MP560.

     
  2. Select [Wireless LAN setup], then press the <OK> button.


     
  3. Select [Yes], then press the <OK> button.
    When wireless connection is enabled, the Wi-Fi lamp (B) lights blue.


     
  4. Select [Easy settings], then press the <OK> button.


     
  5. Select the access point name you wrote down , then press the <OK> button.



    Note:
    *
    If you are living in an apartment, nearby access points in use may be detected.
    * The access point names with 2-byte characters are not displayed properly, however, can be selected.

     
  6. When one of the following screens is displayed, enter the network key you wrote down then press the <OK> button.
    1. If the following screen is not displayed or message Failed to connect to access point appears, make sure the network key is correct, then enter it again.
    2. Use the Easy-Scroll Wheel to select the character. Use the button to move the cursor to the right.

      Note: Enter upper and lower case letters of the alphabet correctly.


       
  7. Make sure that the network key is correct, then press the <OK> button.


     
  8. When the completion screen appears, press the <OK> button, then press the HOME button (C).
    The standby screen returns.


 

SIMS Doc Id

0