When the time of use of the lamp exceeds 1,400 hours (1,800 hours or longer for SX7/X700, 2,300 hours or longer for SX60), the following message (two types) is displayed for 10 seconds each time the projector is turned on.

• When the time of use is 1,400 to 1,500 hours:

1,800 to 2,000 hours for SX7/X700

2,400 to 2,500 hours for SX60

	* [<], [>], the [OK] button, and the [POWER] button are available during this message is displayed.
When the time of use is 1,500 hours or longer: 2,000 hours or longer for SX7/X700 2,500 hours or longer for SX60
	* The [POWER] button is available during this message is displayed.

• This message will not be displayed again if you select [No] in response to the message "Do you want to display this message again?".
• You can check the time of use of the lamp in [Lamp counter] in the [System settings] menu

Caution

• When replacing the lamp, turn off the projector, wait until the cooling fan stops, remove the power plug from the AC outlet, and let the projector stand for at least 1 hour. Otherwise, you may get burned because the main unit is very hot immediately after the projector is turned off.
• Do not touch the inner glass surface when you replace the lamp. Otherwise, the projector's performance may degrade.
• Make sure to handle the lamp carefully and correctly since it may explode if it is scratched or shocked.
• Do not remove screws unless specified.

Replacing Lamp

This projector uses the following lamp.

Lamp type No. SX7/X700: RS-LP04

SX6 : RS-LP02

SX60 : RS-LP03

• Be sure to use the specified lamp.
• A lamp can be ordered from your dealer or Canon home page.

1 Turn off the projector, disconnect the power plug from the AC outlet, and then let the projector stand for at least 1 hour. 2 Loosen a screw with a flathead screwdriver and remove the lamp cover.
3 Loosen two screws, pull up the handle, and then remove the lamp. 4 Fully insert a new lamp and secure it with two screws. * After the installation, be sure to push down the handle.
5 Replace the lamp cover and tighten the screw. 6 Turn on the projector. 7 Bring up the menu and select [System settings] -> [Other settings] -> [Lamp counter] 8 Select [Reset] -> [OK] to reset the lamp counter.