Loading Paper MX320

Article ID: ART130631 | Date published: 05/12/2015 | Date last updated: 08/17/2015


Loading Plain Paper/Photo Paper
  • If you cut plain paper into small size such as 4" x 6" / 10 x 15 cm, 4" x 8" / 101.6 x 203.2 mm, 5" x 7" / 13 x 18 cm, or 2.16" x 3.58" / 55.0 x 91.0 mm (Card size) to perform trial print, it can cause paper jams.

  • We recommend Canon genuine photo paper for printing photos.
  • You can use general copy paper. For the page size and paper weight you can use for this machine,

1.Preparing paper.

Align the loading paper. Flatten the four corners of paper before loading it.

  • Align the edges of paper neatly before loading. Loading paper without aligning the edges may cause paper jams.
  • If paper is curled, hold the curled corners and gently bend them in the opposite direction until the paper becomes completely flat.

2.Load paper.

(1) Open the Paper Support, and open the support as an extension.

(2) Open the Paper Output Tray gently.

(3) Slide the Paper Guides (A) gently to open them, and load the paper in the center of the Rear Tray WITH THE PRINT SIDE FACING YOU.

  • Always load paper in the portrait orientation (B). Loading paper in the landscape orientation (C) can cause paper jams.

(4) Slide the Paper Guides (A) to align them with sides of the paper stack.

Slide the Paper Guides gently.

  • Do not load sheets of paper higher than the Load Limit Mark (D).

  • The machine may make an operating noise when feeding paper.

After loading paper

  • When using the machine to copy, select the size and type of the loaded paper in Page size and Media type of the setting options.

  • When printing with a computer, select the size and type of the loaded paper in Printer Paper Size (or Paper Size) and Media Type in the printer driver.

Loading a Document in the ADF

Load a document to copy, fax, or scan in the ADF.

  • To scan a document at optimum quality, load it on the Platen Glass.

1.Make sure that any original has been removed on the Platen Glass.

2.Load a document in the ADF.

(1) Open the Document Tray.

(2) Insert the document in the Document Tray until it beeps.

Load the document with the side to copy, fax, or scan FACING UP in the Document Tray.

  • When Alarm volume is set to OFF, the alarm will not beep even if the document is inserted in the Document Tray.

(3) Adjust the Document Guides to match the width of the document.

Do not slide the Document Guides too hard. The originals may not be fed properly.



Rate this Article
Was this article helpful?
Yes, This document is helpful
No, This document needs a clearer explanation
Please provide your comments