Using the DV Control

This feature enables the XH A1/G1 to control the record and stop function of a connected IEEE1394 storage/recording device. The device must comply with the IEEE1394 AV/C protocol.

Windows XP (SP2) users can use the CONSOLE software (sold separately) to download video and audio recordings (in HDV or DV standards) from the camcorder to the computer's hard disk. For details refer to the software's help modules..

1. Press the <MENU> button to open the menu and select [SYSTEM SETUP]. Select [DV CONTROL], set it to [ON] and close the menu.
   

2. Press the start/stop button.
   

When the XH A1/G1 are in record pause mode:

When the XH A1/G1 are recording:

When the XH A1/G1 is not ready for recording (no cassette loaded etc.)

After loading a cassette while the connected device is recording:

Pressing the start/stop button again:

The status of the connected device is indicated as follows: Connected device is recording Connected device is in record pause or stop mode Connected device is in a mode other than record pause or stop [DV CONTROL] is set to [ON], but no DV device is connected When the XH A1/G1 stops recording without operating the start/stop button (e.g. tape has reached the end) while the XH A1/G1 and the connected device are recording, the connected device continues recording. When connecting two XH A1/G1s via a DV cable, make sure to set [DV CONTROL] of the connected device to [OFF]. Up to 2 other devices can be connected to the XH A1/G1 for DV control. DV control may not work properly depending on the connected non-Canon device. As long as the built-in rechargeable lithium battery is charged, the DV control setting is retained by the camcorder even if you turn the power off. Make sure to check the setting after use of the DV control function, as the tape in the connected device may be overwritten.