Here are the Parts and Controls - Nomenclature for the SX80 Mk II / SX800

Article ID: ART132644 | Date published: 05/12/2015 | Date last updated: 09/28/2015


(1)-A ANALOG PC-1/DVI-I IN Input Terminal

(/ DVI-I IN) (SX80 II)

(1)-B ANALOG PC-1 Input Terminal

( /IN) (SX800)

Connects an external monitor output from a computer. Receives an analog PC (ANALOG PC-1) or a digital signal (DIGITAL PC, SX80 II).

(2) HDMI IN Terminal (SX80 II)

Receives a digital content image signal (HDMI). Carries video and audio signals across a single cable.



Receives an analog PC signal (ANALOG PC-2).

Use a supplied component cable to receive a component image signal (COMPONENT).

(4) Monitor Output Terminal (MONITOR OUT) (SX80 II)

Outputs an analog RGB signal to display an image on an external monitor.

(5) USB Terminal (SX80 II)

Connects a digital camera or an USB flash memory.

(6) S-VIDEO IN Terminal (SX80 II)

Receives an S-Video signal from AV equipment.

(7) VIDEO IN Terminal

Receives a composite video signal from AV equipment.

(8) AUDIO IN Terminal

The audio input terminals for 3 image input systems other than HDMI-IN. They receive the following audio signals in order from the left.



The speaker outputs the audio signal for the selected image signal.

(9) AUDIO OUT Terminal

The audio output terminal to output an audio to external AV equipment. It outputs the audio signal corresponding to the projected image signal.

(10) Service port (CONTROL)

Exclusively used by the service personnel (it is not used normally).

(11) LAN port (SX80 II)

Connects a LAN cable. Used to connect the projector to the network.

Preparing the Remote Control

Installing Remote Control Batteries

1 Open the battery compartment lid. Slide the lid with it pressed down. 2 Insert batteries. Insert new two AAA-size batteries in the compartment with the + and - poles positioned correctly. 3 Replace the compartment lid.

  • If buttons on the remote control are inoperative when you attempt to operate the projector, replace the batteries with new ones.
  • It is recommended to check the batteries before a presentation.

Remote Control Operating Range

Point the remote control to the infrared remote receiver on the front or rear of the projector whenever pressing any button.

  • Use the remote control within a distance of approximately 5 m (16.4') from the projector.
  • Use the remote control within an angle of 30° in any direction from directly in front of the infrared remote receiver.
  • The remote control may be inoperative if there is an obstacle between the remote control and main unit or the infrared remote receiver on the main unit is exposed to direct sunlight or strong light of lighting equipment.
  • When you use two projectors at the same time, you can change the channel settings to prevent the two remote controls from interfering with each other.



Rate this Article
Was this article helpful?
Yes, This document is helpful
No, This document needs a clearer explanation
Please provide your comments