Remote Operation Using Wi-Fi Remote

Article ID: ART133299 | Date published: 05/12/2015 | Date last updated: 10/22/2015


Remote Operation Using Wi-Fi Remote



After completing the necessary preparations you can start and stop recording from a Wi-Fi-enabled device using the Wi-Fi Remote application.

1 Press [LIVE VIEW ON/OFF] to show the camcorder’s live view image on the Wi-Fi Remote screen.

2 Press [START/STOP] to begin recording.

  • The recording operation indicator changes from [STBY] to [], the center of the START/STOP button lights up in red and the time code display starts running on the Wi-Fi Remote screen.
  • Press [START/STOP] again to pause the recording.



  • Observe the following precautions while the CFor CFaccess indicator is illuminated in red. Failure to do so may result in permanent data loss.
    • Do not open the CF card slot cover of the CF card slot being accessed and remove the CF card.
    • Do not disconnect the power source or turn off the camcorder.
    • Be sure to save your recordings regularly, especially after making important recordings. Canon shall not be liable for any loss or corruption of data.


  • You can use [Other Functions] > [Rec Review] to review part or all of the last clip recorded.

  • If you set an assignable button to [Add OK Mark] or [Add  Mark], you can press the button to add an OK mark or   mark to the last clip recorded.
  • You can use [Other Functions] > [Clips] > [Delete Last Clip] to delete the last clip recorded.  However, you cannot delete the last clip if double slot recording is on.
  • When you set the [Other Functions] > [SDI Rec Command] setting to [On] and you connect the camcorder to another device using the HD/SD SDI terminal, if you start or stop recording with the camcorder, the other device will also start or stop recording.

Rate this Article
Was this article helpful?
Yes, This document is helpful
No, This document needs a clearer explanation
Please provide your comments