• This message will not be displayed again if you select [No] in response to the message "Do you want to display this message again?".

• You can check the time of use of the lamp in [Lamp counter] in the [System settings] menu

Caution

• When replacing the lamp, turn off the projector, wait until the cooling fan stops, remove the power plug from the AC outlet, and let the projector stand for at least 1 hour. Otherwise, you may get burned because the main unit is very hot immediately after the projector is turned off.

• Do not touch the inner glass surface when you replace the lamp. Otherwise, the projector's performance may degrade.

• Make sure to handle the lamp carefully and correctly since it may explode if it is scratched or shocked.

• Do not remove screws unless specified.

Replacing Lamp

This projector uses the following lamp.

Lamp type No. SX6/X600: RS-LP02

SX60: RS-LP03

• Be sure to use the specified lamp.

• A lamp can be ordered from your dealer or Canon home page.

Replacing the Lamp 1 Turn off the projector, disconnect the power plug from the AC outlet, and then let the projector stand for at least 1 hour. 2 Loosen a screw with a flathead screwdriver and remove the lamp cover
3 Loosen two screws, pull up the handle, and then remove the lamp. 4 Fully insert a new lamp and secure it with two screws. * After the installation, be sure to push down the handle.
5 Replace the lamp cover and tighten the screw. 6 Turn on the projector. 7 Bring up the menu and select [System settings] -> [Other settings] -> [Lamp counter]. 8 Select [Reset] -> [OK] to reset the lamp counter