Adjusting Keystone Distortion

The Auto setup function (Auto keystone) automatically adjusts the keystone distortion in a longitudinal direction. Follow the steps below if the function does not adjust the distortion appropriately or you want to adjust the keystone distortion in a horizontal direction.

1 Press the [KEYSTONE] button.

The [Keystone adjustment] windows appears

2 Press the POINTER buttons to adjust the focus.

• You can activate the Auto keystone function if you press the [AUTO SET] button now

3 Press the [OK] button.

• The result of keystone adjustment is memorized. If you place the projector at the same position, the keystone adjustment is not necessary.

• When the Keystone adjustment is selected, signals are processed digitally. The image may look different from the original one.

• The aspect ratio of the image may change after the keystone adjustment.

• Keystone can be adjusted vertically and horizontally within the range of +/-20 degrees. The amount of adjustment may be less than +/-20 degrees depending on the combination of the amount of optical zooming, input signal type, and adjustment direction (vertical or horizontal).

• If the keystone distortion is too large to adjust, move the projector installation position.

• To reset the keystone adjustment to 0, press the [KEYSTONE] button again to display the [Keystone reset] window. On the window, select [OK] with the [<] button, and then press the [OK] button.