Switching the Connection Method to Wireless LAN 1. Press [  ] (Menu). 2. Press [  ] or [  ] to highlight <Network Settings>, and then press [OK].
 3. Press [ ] or [ ] to highlight <Select Wired/Wireless LAN>, and then press [OK].
 4. Press [ ] or [ ] to highlight <Wireless LAN>, and then press [OK].
 Setting the Machine Using WPS (Push Button Mode) 1. Press [ ] (Menu). 2. Press [ ] or [ ] to highlight <Network Settings>, and then press [OK].
3. Press [ ] or [ ] to highlight <Wireless LAN Settings>, and then press [OK].
 4. Press [OK].
 5. Press [ ] or [ ] to highlight <WPS Push Button Mode>, and then press [OK].
 6. Press [  ] to highlight <Yes>, and press [OK].
 7. Within 2 minutes, press and hold the WPS button on the wireless LAN router and/or access point for approximately 5 seconds. * If <Cannot find Access Point> appears, press [OK] to close the screen, and follow the procedure from step 5. 8. Make sure the Wi-Fi indicator blinks. When the wireless LAN router or access point is detected, the Wi-Fi indicator blinks. The next screen is displayed for approximately 2 seconds, and then the Wi-Fi indicator lights. * If an error message appears, press [OK] to close the screen, and repeat starting from step 5. If you cannot detect the access point after retrying, see the following: 9. Wait until the machine sets the IP address automatically (approx. 2 min). If you want to set the IP address manually, see the following. Checking the Wireless LAN Setting is Completed 1. Press [  ] (Status Monitor/Cancel). 2. Press [ ] or [ ] to highlight <Network Information>, and then press [OK].
 3. Press [ ] or [ ] to highlight <IPv4>, and then press [OK].
 4. Press [ ] or [ ] to highlight the options you want to confirm, and then press [OK].
 5. View the information.
 6. Press [ ] (Status Monitor/Cancel) to close the screen. 7. Start the Web browser of a computer which is connected to a network. 8. Enter "http://IP address of the machine/" in the address field and press the [ENTER] key on the keyboard. You can check <IP Address> at step 5.
 9. Check that the screen of the Remote UI is displayed.
 NOTE When Remote UI is not displayed: - Whether the computer and hub are connected using a LAN cable - Whether the <Remote UI On/Off> is set to <On>
| 
