Cleaning the Encoder Film MX432

 

Description

Cleaning the Encoder Film

 

Solution

This article also applies to PIXMA MX439

If vertical lines always appear on printouts or print always shifts from the correct position, or if Error 5100 occurs during printer operation, the Encoder Film inside the printer may be smeared.
Follow the procedures below to check the film condition, and clean it when necessary.
[ Check Encoder Film is clear.]

Check: Check the Encoder Film conditions

1. Press the ON button to turn off the printer.
2. Unplug the power cord from the wall outlet or power strip.
Caution:  Be sure to turn off the printer power and unplug the power cord first.
3. Open the Paper Output Cover.

4. Check if the Encoder Film (A) inside the printer is clear.
(A) Encoder Film (the transparent thin film)

5. If the Encoder Film is smeared as shown below, it needs to be cleaned.

Refer to [ Check: Clean the Encoder Film ] within this webpage.

[ If the Encoder Film is smeared, clean it while following the procedures below.]

Check: Clean the Encoder Film

Items required:
  • Cotton swab
  • Isopropyl Alcohol or window detergent
Caution:  Do not use any other detergents.

1. Moisten a cotton swab with isopropyl alcohol or window detergent. Eliminate extra liquid from the cotton swab.

2. Using the moistened cotton swab, wipe the Encoder Film.
Caution:  Be cautious so that no liquid drops inside the printer.


(A) Encoder Film
(B) Rail
Caution:  Do not contact the rail (B). If the rail is contacted, the print quality may be deteriorated. The Encoder Film (A) is fixed to the printer with the springs at the ends. If the film is pushed too strong, it may be dislocated. Do not push the film. Just gently move the cotton swab over the surface of the film.
Reference:
  • Keep your hands off the printer and clean the film with the tip of the cotton swab, as shown in the photo above.Change the cotton swab to new ones frequently.
3. Eliminate any stains or smearing from the film until the entire film becomes transparent and clear.

 

4. If a trail of liquid is left on the film, clean it using a cotton swab that is moistened with just water.

If moisture is left on the film, eliminate it using a dry cotton swab, and wait until the film dries well.

5. Close the Paper Output Cover, and plug in the power cord of the printer.

6. Press the ON button to turn on the printer.
If an error occurs or strange sound is heard, service is required.

Click the link below to contact Canon Support.

Contact Support
 

 
7. Print the Nozzle Check Pattern, and confirm that the pattern is printed properly.

8. Print desired data, and confirm that the print quality is good.

If the problem persists, check and clean the Encoder Film again.
 

 

SIMS Doc Id

8201545400

Doc ID   ART137592
Updated   04/30/2019

Rate this Article
Was this article helpful?
Yes, This document is helpful
No, This document needs a clearer explanation
 
Please provide your comments