This article describes how to configure the printer's IP address on the Control Panel.
 

1. On the Tab Selection screen of the Control Panel, press or to select the Settings/Adj. tab ( ).
    

   	Note
   	If the Tab Selection screen is not displayed, press the Menu button.

   
   
2. Press the OK button.
   The Set./Adj. Menu is displayed.
   
3. Press or to select Interface Setup, and then press the OK button.
   
4. Press or to select TCP/IP, and then press the OK button.
   
5. Press or to select IPv4, and then press the OK button.
   
6. Press or to select IPv4 Settings, and then press the OK button.
   
7. Press or to select IP Address, and then press the OK button.
   
8. After you press or to select the input field, numerical input is possible.
   
9. Press the or button to enter the value.
    

   	Note
   	Pressing the button increases the number by 1. The maximum value is 9, after which 0 is displayed. Pressing the button decreases the number by 1. The minimum value is 0, after which 9 is displayed. Hold down or to increase or decrease the value continuously. Make sure the IP address you enter for the printer is not the same as any computer IP address in your network.

   
   
10. Repeat steps 8 and 9 to complete the settings, and then press the OK button.
    
11. Press the Menu button.
    If you have change the settings, a confirmation message is displayed. Press or to select Yes, and then press the OK button.
     

	Important
	Be sure to complete step 11. This will activate the values you have entered. You can also specify the subnet mask and default gateway on the Control Panel. The DNS can also be configured from the printer Control Panel.

	Note
	If an error message is displayed, check the settings and correct any invalid values.