|
|
Removing the Packing Materials (LBP6000)
| Article ID: ART137967 |
| |
Date published: 05/13/2015 |
| |
Date last updated: 08/15/2015 |
Description
Removing the Packing Materials
|
Store the removed packing materials They are required when transporting the printer for relocation or maintenance. About the packing materials The packing materials may be changed in form or placement, or may be added or removed without notice. |
1
Open the output tray.
2
Tilt the paper toward you.
3
Holding the opening (A) on the right side, open the top cover.
4
Tilt the paper toward the back.
5
Remove the packing material inside the top cover.
6
Remove the toner cartridge.
7
Shake the toner cartridge five or six times as shown in the figure to evenly distribute the toner inside the cartridge.
8
Place the toner cartridge on a flat surface.
9
Remove the packing material shown in the figure.
10
Remove the tab, and then pull out the sealing tape (approx. 20 in. (50 cm)).
IMPORTANT |
Precautions when pulling out the sealing tape Do not pull the sealing tape diagonally, upward, or downward. If the tape is severed, this may become difficult to pull out completely. If the sealing tape stops at midpoint, pull it out of the toner cartridge completely. If any tape remains in the toner cartridge, this may result in poor print quality. Dispose of the removed sealing tape according to local regulations. |
11
Remove the packing material with paper inside the top cover.
A plastic part attached to the end of paper (A) is also a packing material. Be sure to remove it.
12
Install the toner cartridge.
Push the toner cartridge into the printer firmly until it touches the back of the printer while aligning (A) on sides of the toner cartridge with the toner cartridge guides inside the printer.
13
Close the top cover.
If you cannot close the top cover Make sure that the toner cartridge is installed in the printer properly. Do not try to forcefully close the top cover, as this may damage the printer. |
14
Open the multi-purpose tray.
15
Remove the tape attached to the printer.
Check ! |
Checking if the packing materials are removed Check that the following packing materials are completely removed. |
