Clean the timing (encoder) strip - MX922

Article ID: ART142447 | Date published: 05/13/2015 | Date last updated: 03/08/2019


Learn how to clean the timing strip inside your PIXMA MX922 printer. Includes symptoms of a dirty timing strip and how it might get dirty.


About the timing strip

The timing strip is a clear, plastic strip approximately 1/4" in height positioned horizontally across the center of the unit, just in front of the carriage drive belt. The timing strip contains many thin black vertical lines that help determine the carriage position during operation.

                         Select to see a larger image.

How it can get dirty
During certain uncommon tasks such as the removal of a paper jam, it is possible to inadvertently touch a lubricated area on the printer's chassis causing a small amount of grease to be deposited onto the timing strip.

Symptoms of a dirty timing strip
Grease on the timing strip may result in poor print quality including; mis-aligned or distorted characters, vertical lines or, in some cases, an inoperable error condition (such as 5100) or knocking / grinding noise.

Clean the timing strip

In most cases, it is easy to remove the grease from the timing strip using common household items. If you wish, you may follow the steps below to remove the grease from the timing strip.

Items needed:
  • Clean, unused cotton swab
  • Small amount of Isopropyl Alcohol or window cleaner
  • Flashlight or other light source


  1. Holding the sides of the paper output tray, gently open it.
  2. Open the document cover.

  3. Open the ink cover.

    The Print Head Holder (carriage) will move to ink changing (center) position.
  4. With the ink cover open, unplug the power cord from the wall outlet or power strip.
    Note: check the printer's power LED is no longer illuminated.
  5. Hold the top of the print head holder and slide it slowly to the right edge.

    The above illustration shows a PIXMA MG6320.
  6. When the carriage is to the far right, you will be able to see the timing strip.


  7. Using a flashlight, carefully inspect the timing strip for grease and dirt. It is helpful to view the timing strip from several angles as even a small amount of grease can impact print quality.

    The timing strip is a clear strip located in front of the drive belt.
  8. Moisten the cotton swab with Isopropyl alcohol (or window cleaner), and carefully remove the grease from the timing strip.
    Note: do not touch or remove grease from the chassis (metal rail).
  9. Once you have confirmed that the left and center portions of the timing strip are clean, gently slide the carriage all the way to the left.
  10. Repeat steps 4 & 5 for inspecting the right side of the timing strip until is completely free of grease and dirt.
  11. Gently close the ink cover, then close the document cover.

  12. Reconnect the power cord and power on the printer.
    (The indicator light blinks steadily while the printer initializes.)
  13. After the printer is powered back on, the printer's LCD displays a message that the printer was not properly turned off. Tap OK to clear the message and return the printer to standby mode.
  14. Print a test document and photograph. If print quality is still poor, repeat the above steps.


MX922 Page



Rate this Article
Was this article helpful?
Yes, This document is helpful
No, This document needs a clearer explanation
Please provide your comments