The steps listed below are specific to the iP7220.  For instructions for other models, click here.

You can print out the network settings of the printer such as its IP address and SSID.

 This print out contains valuable information about your computer. Handle it with care.

1. Make sure that the printer is powered on.

2. Load a sheet of A4 or Letter-sized plain paper.

3. Press and hold the RESUME/CANCEL button until the POWER lamp flashes 6 times.

4. Release the RESUME/CANCEL button.

   The printer starts printing the network setting information.

   The following information on the printer's network setting is printed out.

   Item	Explanations of the item	Setting
   Wireless LAN	Wireless LAN	Enable/Disable
   Connection	Status of the Wireless LAN	Active/Inactive
   MAC Address	MAC Address	XX:XX:XX:XX:XX:XX
   SSID	SSID	SSID of the wireless LAN
   Communication Mode	Communication Mode	Infrastructure
   Channel	Channel	XX (1 to 13)
   Encryption	Method of the Encryption	none/WEP/TKIP/AES
   WEP Key Length	WEP Key Length	Inactive/128/64
   Authentication	Method of the Authentication	none/auto/open/shared/WPA-PSK/WPA2-PSK
   Signal Strength	Signal Strength	0 to 100 [%]
   TCP/IP Version	TCP/IP Version	IPv4 & IPv6/IPv4
   IPv4 IP Address	Selected IP Address (IPv4)	XXX.XXX.XXX.XXX
   IPv4 Default Gateway	Default Gateway (IPv4)	XXX.XXX.XXX.XXX
   Subnet Mask	Subnet Mask	XXX.XXX.XXX.XXX
   IPv6 IP Address *1	Selected IP Address (IPv6)	XXXX.XXXX.XXXX.XXXX XXXX.XXXX.XXXX.XXXX
   IPv6 Default Gateway *1	Default Gateway (IPv6)	XXXX.XXXX.XXXX.XXXX XXXX.XXXX.XXXX.XXXX
   Subnet Prefix Length*1	Subnet Prefix Length	XXX
   IPsec*2	IPsec setting	Active
   Security Protocol*2	Method of the Security Protocol	ESP/ESP & AH/AH
   WPS PIN CODE	WPS PIN code	XXXXXXXX
   Wireless LAN DRX	Discontinuous reception (wireless LAN)	Enable/Disable
   Other Settings	Other settings	-
   Printer Name	Printer name	Printer name (Up to 15 characters)
   WSD	WSD setting	Enable/Disable
   WSD Timeout	Timeout	1/5/10/15/20 [min]
   LPR Protocol	LPR protocol setting	Enable/Disable
   Bonjour	Bonjour setting	Enable/Disable
   Bonjour Service Name	Bonjour service name	Bonjour service name (Up to 52 characters)
   IP Address Filtering	IP Address Filtering	Enable/Disable

   ("XX" represents alphanumeric characters.)

   *1 Only when IPv6 is activated, the status of the network is printed.

   *2 Only IPv6 and the IP sec setting are activated, the status of the network is printed.

If your product issue was not resolved after following the steps above, or if you require additional help, please create or log in to your Canon Account to see your technical support options.

Or if you still need help, visit our Canon Community by clicking the button below to get answers: