If printed vertical lines are warped or colors are out of alignment, execute Head Posi. Adj. to adjust the Printhead alignment. Normally, execute Standard. However, when printing on special paper, or if printing is not improved after Standard, try Manual. Manual adjustment requires you to examine the printed test pattern and enter an adjustment value.
 NOTE - We recommend using the type of paper you use most often for adjustment.
- If the printhead position was not adjusted during initial setup or when the printhead was replaced, execute Initial adjustmt.
<Items to Prepare> When Using Rolls : An unused roll at least 254.0 mm (10.00 in) wide When Using Sheets : Two sheets of unused paper, A4/Letter size (or one sheet when using A2) Perform adjustment as follows. 1. Load paper. IMPORTANT - Always make sure the loaded paper matches the type of paper specified on the printer. Adjustment cannot be completed correctly unless the loaded paper matches the settings.
2. On the Tab Selection screen of the Control Panel, press  or  to select the Settings/Adj. tab (  ).
 NOTE - If the Tab Selection screen is not displayed, press the Menu button.
3. Press the OK button. The Set./Adj. Menu is displayed. 4. Press  or  to select Adjust Printer, and then press the OK button. 5. Press  or  to select Head Posi. Adj., and then press the OK button. 6. Press  or  to select Other, and then press the OK button. 7. Press  or  to select Manual, and then press the OK button. A test pattern is printed for adjustment. NOTE - Manual may be unavailable in some cases, even if it is displayed in the menu.
If so, execute Standard once.
8. Press  or  to select D, and then press the OK button. 9. Press  or  to select D-1, and then press the OK button. 10. Examine adjustment test pattern D-1 and determine the number with straight lines.
 NOTE - If two patterns seem equally good and you cannot decide which one is better, choose an intermediate value.
For example, choose 11 if you cannot decide whether pattern 10 or 12 is better.
11. Press  or  to select the pattern number you have decided, and then press the OK button. 12. Repeat steps 810 to specify the adjustment value for D-1 to D-5, D-7 to D-12, D-25 to D-29, and D-31 to D-36. 13. Press the Back button. 14. Press  or  to select Register Setting, and then press the OK button. 15. Press  or  to select Yes, and then press the OK button. The adjustment value is now registered, and adjustment is complete.
| 