 |
Check that RATIO A : B : C is displayed on the LCD panel
- If it is not displayed, press the <RATIO> button until it is displayed
Check that the sender unit's pilot lamp is lit and that receiver C is also flash-ready
Focus and take the picture
Check that the sender unit's flash exposure confirmation lamp lights
|
- If the flash output of flash tube A or B or receiver C is insufficient, the sender unit's flash exposure confirmation lamp will not light
- If you use receiver C to illuminate the subject directly, overexposure of the subject may result.
- If you set RATIO A : B, receiver C will not fire
- In a wireless flash system, the sender unit will always fire flash tubes A and B. You cannot fire only one flash tube in a wireless flash system
You can also set a flash ratio for flash tubes A and Be and set the flash exposure compensation for receiver C.
 |
Check that RATIO A : B : C is displayed on the LCD panel
- If it is not displayed, press the <RATIO> button until it is displayed
Press the  button to set a flash ratio for flash tubes A and B
- The diagram on the left show the left / right ratio set to 4:1
- When RATIO is displayed, you can change the flash ratio anytime
Press the <+> or <-> button to set receiver C flash exposure compensation amount
- The amount can be set up to +/-3 stops in 1/3 or 1/2-stop increments
Check that the sender unit's pilot lamp is lit and that receiver C is also flash ready
Focus and take the picture
|
