Changing copy / fax resolution settings (FAX-JX210P)

Article ID: ART152468 | Date published: 05/22/2015 | Date last updated: 12/28/2015


Resolution is a measure of the fineness or clarity of a printout.


Set the Scan Resolution

Resolution is a measure of the fineness or clarity of a printout. Low resolutions may cause text and graphics to have a jagged appearance. while higher resolutions provide smoother curves and lines, crisp text and graphics, and a better match to traditional typeface designs.

Note (Copy): <COPY STANDARD> and <COPY FINE> result in the same resolution when making copies.

Note (Fax): Using a higher resolution will increase the output quality, but will slow down the scanning speed.

  1. Insert the top of the document, face up, into the ADF until a beep is heard.

  2. Adjust the document guide to the width of the document.

  3. Press <Receive Mode/Resolution> to select the resolution.
    The selections for copying are <COPY STANDARD>, <COPY FINE>, or <COPY DRAFT>.
    The selections for faxing are [FAX STANDARD], [FAX FINE] or [FAX PHOTO].

    Note: You cannot change the resolution setting while the machine is sending a fax or after it starts scanning.

  4. Press <Start/Copy>.

  5. Perform the next step as follows.
    1. To send a fax, dial the receiving party's fax number and then press <Start/Copy.
    2. To make a copy, enter the number of copies (up to 99) using the numeric buttons.
      To make a correction to the number of copies, press <Clear> and re-enter the number.
    3. Press <Start/Copy>.
      To stop copying anytime, press <Stop/Reset>. If the document does not eject, press <Start/Copy> for a few seconds, then the fax will feed out the document.

  6. The new resolution will remain until it is changed.



Rate this Article
Was this article helpful?
Yes, This document is helpful
No, This document needs a clearer explanation
Please provide your comments