Changing copy / fax resolution settings (FAX-JX210P)
Article ID: ART152468 | Date published: 05/22/2015 | Date last updated: 12/28/2015


Resolution is a measure of the fineness or clarity of a printout.


Set the Scan Resolution

Resolution is a measure of the fineness or clarity of a printout. Low resolutions may cause text and graphics to have a jagged appearance. while higher resolutions provide smoother curves and lines, crisp text and graphics, and a better match to traditional typeface designs.

Note (Copy): <COPY STANDARD> and <COPY FINE> result in the same resolution when making copies.

Note (Fax): Using a higher resolution will increase the output quality, but will slow down the scanning speed.

  1. Insert the top of the document, face up, into the ADF until a beep is heard.

  2. Adjust the document guide to the width of the document.

  3. Press <Receive Mode/Resolution> to select the resolution.
    The selections for copying are <COPY STANDARD>, <COPY FINE>, or <COPY DRAFT>.
    The selections for faxing are [FAX STANDARD], [FAX FINE] or [FAX PHOTO].

    Note: You cannot change the resolution setting while the machine is sending a fax or after it starts scanning.

  4. Press <Start/Copy>.

  5. Perform the next step as follows.
    1. To send a fax, dial the receiving party's fax number and then press <Start/Copy.
    2. To make a copy, enter the number of copies (up to 99) using the numeric buttons.
      To make a correction to the number of copies, press <Clear> and re-enter the number.
    3. Press <Start/Copy>.
      To stop copying anytime, press <Stop/Reset>. If the document does not eject, press <Start/Copy> for a few seconds, then the fax will feed out the document.

  6. The new resolution will remain until it is changed.