Cleaning the Machine
Article ID: ART152574 | | | Date published: 05/22/2015 | | | Date last updated: 10/07/2015 |
Description
Cleaning the Machine
Solution
Cleaning the Machine ID : 8201415800 _ EN _ 1 | |
Solution | Cleaning the Exterior Clean the exterior of the machine and ventilation slots. 1. Turn OFF the power switch, and then disconnect the power cord. 2. Clean the exterior of the machine with a soft, well wrung out cloth dampened with water or a mild detergent that has been diluted with water. ![]() 3. Wait for the machine to dry completely before reconnecting the power cord, and then turn ON the power. Cleaning the Interior Clean the machine's print area periodically to prevent toner powder and paper dust from accumulating inside. 1. Turn OFF the power switch, and then disconnect the power cord. 2. Hold the upper unit. ![]() 3. Lift the upper unit. ![]() 4. Hold the grip on the left front side of the toner cover. ![]() 5. Open the toner cover. ![]() 6. Remove the toner cartridge. ![]() 7. Remove any toner or paper debris from interior of the machine, with a clean, soft, dry, and lint-free cloth. 8. Insert the toner cartridge. Fit the protrusions (A) on each side of the toner cartridge into the guides located on each side of the machine. Slide the toner cartridge into the machine, until the toner cartridge meets the back of the machine. ![]() 9. Close the toner cover.
10. Lower the upper unit. 11. Connect the power cord, and then turn ON the power switch. Cleaning the Fixing Unit You should clean the fixing unit when
1. Press [ ![]() 2. Press [ ![]() ![]() ![]() 3. Press [ ![]() ![]() ![]() 4. Check if the supported paper is set in the paper cassette, and then press [OK]. The cleaning begins. It takes approximately 120 seconds to complete the process. ![]() * We recommend that you load plain paper when cleaning the fixing unit.
5. Press [ ![]() Cleaning the Feeder If your document has black streaks or appears dirty after it has been scanned from the feeder, the rollers inside the feeder may be dirty. Clean the feeder's scanning area and rollers. 1. Turn OFF the power switch, and then disconnect the power cord. 2. Lift the operation panel. ![]() 3. Clean the rollers (A) inside the feeder with a well wrung out cloth dampened with water and wipe them with a soft, dry cloth. ![]() 4. Lower and close the operation panel until it is locked. ![]() * Push down the operation panel until it is locked. 5. Connect the power cord, and then turn ON the power switch. Attention (Cleaning the Machine) Before cleaning the machine, note the following.
|
SIMS Doc Id
8201415800