Replacing the Lamp

When the usage time of the lamp exceeds a certain amount of time, the following message (two types) is displayed for 10 seconds every time the projector is turned on.

2,700 hours to less than 3,000 hours

Prepare the new lamp when this screen is displayed.

• Only the , OK and POWER buttons are available while this screen is displayed.

• When you press the POWER button, “Push POWER button again to turn off power.” message appears.

• After this screen has been displayed for 10 seconds and disappeared, all buttons become operable.

• This message will not be displayed again if you select [Cancel] in response to the message “Do you want to display this message again?”.

3,000 hours or more

If this screen is displayed, replace the lamp

• Only the POWER button is available while this screen is displayed.

• When you press the POWER button, “Push POWER button again to turn off power.” message appears.

• When this screen has been displayed for 10 seconds and disappeared, all buttons become operable.

• You can check the usage time of the lamp in [Lamp counter] in the [System settings] menu.

Replacement Lamp

This projector uses the following lamps.

Lamp part No.:     RS-LP06 (WUX4000)

                              RS-LP07 (WUX5000 / WUX4000)

Contact the Canon Customer Support Center when purchasing a replacement lamp.

When replacing the lamp, turn off the projector, wait until the cooling fan stops, disconnect the power plug from the AC outlet, and let the projector stand for at least 1 hour. Otherwise, you may get burned because the main unit is very hot immediately after the projector is turned off.

The lamp cover screw is attached to the lamp cover and designed to prevent it from falling off.

• Be sure to use the specified lamp.

• Contact the Canon Customer Support Center or access to the Canon home page.

• Do not touch the inner glass surface when you replace the lamp. Doing so may cause deterioration to the projector’s performance.

• Be sure to handle the lamp carefully and correctly since it may break during use if it has been scratched or subjected to impact.  If the lamp breaks, contact the Canon Customer Support Center or follow the instructions in “Precautions on the lamp” and “Lamp handling precautions”

• When replacing the lamp, do not remove any screws other than those specified

Replacing the Lamp

1 Turn off the projector power and remove the power plug.

2 Loosen one screw and open the lamp cover in the direction of the arrow.

3 Loosen the 3 screws on the inside of the lamp unit, then slowly pull out the lamp unit in the direction of the arrow. Even when the screws are loosened, they will not fall off the lamp unit.

4 Fully insert a new lamp unit and secure it with the 3 screws.

5 Close the lamp cover and tighten the screws.

6 Turn on the power. Bring up the menu and select [System settings] - [Other settings] - [Lamp counter].

7 Select [Reset] - [OK] to reset the lamp counter.

• It is recommended that you also replace the air filter when you replace the lamp.

• Contact the Canon Customer Support Center for further information.

• Replacement air filter product number: RS-FL01