How to recharge the EOS 5D battery.

Article ID: ART154427 | Date published: 06/09/2015 | Date last updated: 11/04/2015
 

Description

How to recharge the EOS 5D battery.

Solution

1. Remove the cover.
  • When you remove the battery from the camera, be sure to reattach the cover to protect against short circuit.
2. Attach the battery.
  • Align the battery front edge with the <?> mark on the battery charger. While pressing down the battery, slide it in the direction of the arrow.
  • To detach the battery, follow the above procedure in reverse.
3. For CG-580

Flip out the prongs and recharge the battery.

  • As shown by the arrow, flip out the battery charger?s prongs.
  • Insert the prongs into a power outlet.
For CB-5L

Connect the power cord and recharge the battery.

  • Connect the power cord to the charger and insert the plug into the power outlet.
  • Recharging starts automatically and the red lamp starts blinking.
  • The recharging time for a completely exhausted battery is as follows: BP-511A and BP-514: Approx. 100 min. BP-511 and BP-512: Approx. 90 min.

The numbers and markings on the battery charger correspond to the table below.

Recharge Level Red Lamp
0-50% Blinks once per second
50-75% Blinks twice per second
75-90% Blinks three times per second
90% or higher Lights on
  • Do not recharge any battery pack other than Battery Pack BP-511A, BP- 514, BP-511, or BP-512.
  • If the battery is left in the camera for a prolonged period without the camera being used, a low electrical current may be discharged excessively and the battery?s service life may be affected. When not using the camera, remove the battery and attach the protective cover to prevent shorting. Before using the camera again, be sure to recharge the battery.
  • Storing the battery while fully charged may reduce its service life or performance.
  • Battery Packs BP-511A, BP-514, BP-511, and BP-512 are dedicated to Canon products. Using them with a non-Canon battery charger or product may result in malfunction or accidents for which Canon cannot be held liable.
  • After the red lamp lights, continue to recharge the battery for an hour to attain a full charge.
  • Even a recharged, unused battery will gradually drain its power. Recharge the battery on the day before or on the day you plan to use it.
  • By referring to the marking, you can attach the protective cover to the battery to indicate whether the battery has been recharged or not.
  • After recharging the battery, detach it and unplug the power cord from the power outlet.
  • The time required to recharge the battery depends on the ambient temperature and battery?s recharge level.
  • The battery pack can operate in temperatures from 0?C to 40?C (32?F to 104?F). However, for full operating performance, using it between 10?C (50?F) and 30?C (86?F) is recommended. In cold locations such as ski areas, battery performance temporarily decreases and the operating time may be shorter.
  • If operating time is sharply reduced even after normal recharging, the battery pack may have reached its service life. Replace it with a new battery.

SIMS Doc Id

0

Rate this Article
Was this article helpful?
Yes, This document is helpful
No, This document needs a clearer explanation
 
Please provide your comments