When you play back a tape that was recorded in 12-bit mode, you can set the audio output to stereo 1 (the original sound), stereo 2 (any new sound, dubbed to the tape after recording), or mix the balance between the two.
Select the output channel.
-
Press AUDIO MONITOR on the wireless controller.
-
Starting with the last selected setting, 4 settings appear as you push the button:
-
STEREO1 for just stereo 1.
-
STEREO2 for just stereo 2.
-
MIX/FIXED for an equal mix of stereo 1 and 2.
-
MIX/VARI. (mix variable) for when you want to mix the balance between stereo 1 and 2.
-
If you choose MIX/VARI., you can go on to mix the balance.
-
Use the ST-1/ST-2 buttons to mix the balance. A bar showing the balance appears on the screen for 4 seconds.
Note:
-
When you have chosen the output, STEREO1, STEREO2, MIX/FIXED or MIX/VARI. is shown in the top left of the display for a few seconds. If you turn the power off, the output becomes set to STEREO1.
Selecting Audio Output Channels
When you play back a tape whose audio has been recorded on multiple channels, you can change the output channels of that sound.
-
Load a tape recorded with multiple-channel audio.
-
Open the menu and select VCR SET UP. Then select OUTPUT CH, set it to the desired setting and close the menu.
-
Refer to the following list.
OUTPUT CH Setting
|
Playback Sound
|
Tape Recorded With
Stereo Sound
|
Tape Recorded On
Multiple Channels
|
L/R
|
L+R channels
|
main + sub
|
L/L
|
L channel only
|
main only
|
R/R
|
R channel only
|
sub only
|