Transporting Your Machine

If the copier will be subjected to vibration (e.g., when transporting over long distances), the following precautions should be taken. If you do not follow these precautions, the copier may get damaged or the quality of your copy images may be adversely affected. Also, if the copier is still hot when carrying out the steps below, you may not be able to attach the shipping attachments. If this happens, let the copier cool down for at least two hours and then try again.

1. Press the power switch <ON>.
   
   
   
2. Press the <Preset Copy Ratio> key and select a ratio of 70%.
   
   
   
3. Insert a sheet of the copy stock into the single-sheet bypass. The copier will perform an automatic adjustment operation so that you can attach shipping attachment (2).
   
   
   
4. Turn [OFF] the copier and unplug it.
   
   
   
5. Lift the main unit lever on the left side to open the top of the main unit.
   
   
   
6. Pull out shipping attachment (1(bronze colored screw)) and (2(black colored screw)) from the shipping attachment holder; these attachments were inserted in the shipping attachment holder during the installation of your copier.
   
   
   
   
7. Grip the end of the cartridge, and pull it out of the copier.
   
   
   
8. Close the main unit by pressing down firmly on the part marked "".
   
   
   
9. Re-attach shipping attachment (1(bronze colored screw)) on the left side of the main unit and which was pulled out of the shipping attachment holder in step 7.
   
   
   
   
10. Re-attach shipping attachment (2(black colored screw)) on the right side of the main unit and which was pulled out of the shipping attachment holder in step 7.
    
    
    
    • When carrying this machine, be sure to hold it in the designated places as shown in the illustration. Dropping the machine can cause personal injury.
      
    • Place the copier on a level, stable surface.
    • Do not leave the copier inside a car for a long
    • Avoid rough roads; excessive vibration may damage the copier or adversely affect the quality of your copy images.
    • Place a cover over the copier. Do not leave the copier in direct sunlight.
    • When moving the copier, use the original shipping box that it was packed inside when you purchased it.
    • When using the original shipping box, do not place the power cord on the platen glass cover; this may damage the platen glass.