Install the Ink Tanks Correctly iP6000D
Article ID: ART159810 | Date published: 06/09/2015 | Date last updated: 08/18/2015


Install the Ink Tanks Correctly iP6000D


Install the Ink Tanks Correctly

  1. Confirm that the printer is powered on.

  2. Open the paper output tray and top cover. 

    Note:  Gently open the paper output tray while holding it.

  3. After confirming that the print head holder has moved to the center, open the inner cover.

    Note:  Before installing the ink tank, confirm that the print head has been installed.

  4. Remove the magenta ink tank (BCI-6M) from its package. Pull the orange tape in the direction of the arrow to remove the wrap film completely. 

    Note:  Remove the orange tape completely.  If the orange tape is left, printing may not be performed normally.

    <1> Removed correctly
    <2> Removed incorrectly

  5. Hold the ink tank as shown in the image below. Twist the orange protective cap in the direction of the arrow, and remove it. 

    Note:  Remove the protective cap while holding it, so that fingers will not be stained by the ink. 

  6. Insert the ink tank into the slot at the right end, and push down on the PUSH mark on top of the ink tank until a click sound is made.  Install the other ink tanks in the same manner.

  7. Close the inner cover and top cover.

    Ink Tanks' Installation Order

    Note:  Check that each ink tank is installed in the correct position. 

    Properly installed:

    Improperly installed:

    Left Image:  The M ink tank is not fully seated.
    Right Image:  All ink tanks are not fully seated.