Preparing to Transfer the Printer (iPF830/iPF840/iPF850)
Article ID: ART162649 | | | Date published: 10/01/2015 | | | Date last updated: 12/02/2015 |
Description
Preparing to Transfer the Printer (iPF830/iPF840/iPF850)
Solution
Solution |
To protect the internal parts in transit, always follow these steps before transferring the printer to a new location.
Refer to the Setup Guide for details on packing the printer and installing it after transfer.
Remove paper 1.Disassemble and repackage the Wheeled Output Stacker by following the installation procedure in reverse.(iPF840)
Disassemble and repackage the Stacker by following the installation procedure in reverse.(iPF850)
2.Remove the paper.
Access the Prep.MovePrinter menu 1.If a message instructing you to replace the Maintenance Cartridge is displayed on the Display Screen, replace the Maintenance Cartridge.
2.On the Tab Selection screen of the Control Panel, press
![]() ![]() ![]() ![]()
3.Press the OK button.
The Set./Adj. Menu is displayed.
4.Press
![]() ![]()
5.Press
![]() ![]() Displays the confirmation screen.
6.Press
![]() ![]() The printer is now prepared for transfer.
<Level 1>
Once preparations are finished, a message on the Display Screen requests you to turn off the printer.
Turn off and pack the printer. There is no need to remove the ink tanks.
<Level 2 and Level 3>
When the preparation is finished, instructions are displayed on the Display Screen.
Remove the ink tanks before packing the printer.
Removing Ink Tanks 1.Open the Ink Tank Cover.
![]()
2.Lift the stopper (a) of the Ink Tank Lock Lever (a). Lift the Ink Tank Lock Lever until it stops, and then push it down to the front.
![]()
3.Hold the Ink Tank by the handle (a) and remove it.
![]()
4.Repeat steps 2 and 3 to remove all ink tanks.
![]()
5.Push down the release lever (a) as shown as you gently return all ink tank lock levers to the original position.
![]()
6.Close the Ink Tank Cover.
At this point, ink is drawn out from inside the tubes.
![]()
7.When the process is finished, "Preparations for moving the printer finished. Turn the power off" is displayed.
When this happens, replace the Maintenance Cartridge currently being used with a new Maintenance Cartridge.
8.Press the Power button and turn off the printer.
![]() Pack the printer 1.Disconnect the power cord and interface cable, as well as the Media Take-up Unit cable.
2.Open the Top Cover and lift the Ejection Guide.
![]()
3.Remove the four ejection supports and lower the Ejection Guide.(iPF830/iPF850)
![]()
4.Grasp the Belt, insert it between the Belt Stopper, and affix the Belt Stopper with a hex screw at the position indicated.
![]()
5.Close the Top Cover.
![]()
6.Tape down printer covers to secure them, in the reverse order of tape removal during installation.
![]()
7.Remove and package the Output Stacker by reversing the installation procedure.(iPF830)
8.Remove and package the Stand by reversing the installation procedure, when it was attached to the printer.
9.Disassemble and repackage the Stand by following the installation procedure in reverse.
10.Repack the Roll Holder, Holder Stopper, and printer in shipping materials, and then package them in a shipping box.
|
ID: 8202697900_EN_1
|
SIMS Doc Id
8202697900