Using the Image Stabilizer

Article ID: ART163652 | Date published: 11/18/2015 | Date last updated: 11/18/2015


Using the Image Stabilizer


While you look through the binoculars, the Image may be shaking and difficult to see since your hands are holding the binoculars in such a case the Image Stabilizer can help steady the image.
There are two ways to use the lmage Stabilizer You can turn on the lmage Stabilizer as long as you hold down the image Stabilizer button and or you can turn on the lmage Stabilizer for 5 minutes
Holding down the button
the Image Stabilizer operates continuously while you hold down the button. When you let go of the button, the, lmage Stabilizer stops operating
  Five-minute operation
Press the lmage Stabilizer button slowly and quickly let it go, and the lmage Stabilizer will operate continuously for about five minutes.
To stop the lmage Stabilizer operation.
press the button again.
The lamp lights while the Image Stabilizer is on.
The lmage Stabilizer may not be able to compensate for severe shaking
If the binoculars are attached to a tripod, it will compensate for the small vibrations xxxx to tripod use If the binoculars face down for more than 10 seconds, such as when they are hanging from the strap. The lmage Stabilizer will turn off to conserve power To use the binoculars in downward direction, keep pressing the lmage Stabilizer switch.
When the battery power is Iow, the Image Stabilizer may generate noise and vibration The Image Stabilization is not affected by this.
Even without batteries loaded, the binoculars can be used as is.

Rate this Article
Was this article helpful?
Yes, This document is helpful
No, This document needs a clearer explanation
Please provide your comments