Configuring the Flash Settings (PowerShot SX540 HS)

Article ID: ART164273 | Date published: 01/11/2016 | Date last updated: 01/11/2016


Configuring the Flash Settings (PowerShot SX540 HS)


Follow the steps below to configure the flash settings.

Fires for each shot (On).

If you set the [Flash] to [Auto], the [Flash] will not fire in bright environments. However, if for example you take a shot of people against a backlight, the [Flash] will fire even when you shoot in daylight to prevent the faces from becoming obscured.
The instructions below refer to the setting that makes the [Flash] fire for each shot (On).
  • The instructions in this section apply to a camera with the [Shooting Mode] set to [Program AE] ( ).
Shooting Mode with Limited Flash Settings

1. Turn on the [Power] on the camera.

2. Lift the [Flash] with your finger.

3. Press the [ ] button.

  • The setting screen cannot be accessed by pressing the [ ] button when the flash is lowered. First, lift the flash with your finger.
  • If the flash fires, vignetting may occur.

4. The flash setting screen will appear.
Press the [ ], [ ] buttons to select [ : On ], and then press the [ ] button.

5. When the icon changes to [ ], the configuration of settings is complete.

You can select one of the following 4 flash modes.
For details on the available shooting modes, refer to the instruction manual supplied with the camera.
[ Auto : ]
  • Fires automatically in low-light conditions.
[ On : ]
  • Fires for each shot.
[ Slow Synchro : ]
  • Fires to illuminate the main subject (such as people) while shooting at a slower shutter speed to illuminate backgrounds out of flash range.
[ Off : ]
  • For shooting without the flash.
The flash cannot be configured in the following shooting modes.
... Not configurable
FunctionShooting mode
*1*1 *1
*1 Not available, but switches to in some cases.

When [Raise the Flash] is Displayed

When shooting in a dark environment in the [AUTO] mode or in the [Plus Movie Auto] mode, the message [Raise the Flash] may appear on the LCD screen. If that happens, lift the flash with your finger.
If you don't lift the flash, it will not fire. (The flash is never lifted automatically.)

When the message above appears, lift the flash with your finger as described below.

Flash Range

If your shots are dark despite the flash firing, move closer to the subject.
See the table below for details on the flash range.
Maximum Wide Angle 50 cm - 5.5 m (1.6 – 18 ft.)
Maximum Telephoto 1.3 m - 3.0 m (4.3 – 9.8 ft.)



Rate this Article
Was this article helpful?
Yes, This document is helpful
No, This document needs a clearer explanation
Please provide your comments