Configuring the Flash Settings (PowerShot SX720 HS)
Article ID: ART164636 | | | Date published: 02/22/2016 | | | Date last updated: 06/29/2023 |
Description
Configuring the Flash Settings (PowerShot SX720 HS)
Solution
Solution |
Follow the steps below to configure the flash settings. Fires for each shot (On). If you set the [Flash] to [Auto], the [Flash] will not fire in bright environments. However, if for example you take a shot of people against a backlight, the [Flash] will fire even when you shoot in daylight to prevent the faces from becoming obscured.
The instructions below refer to the setting that makes the [Flash] fire for each shot (On).
Shooting Mode with Limited Flash Settings 1. Turn on the [Power] on the camera. 2. Move the [Flash pop up] ( The flash will not auto pop-up. It must be manually raised with the switch. ![]() 3. Press the [ ![]()
4. The flash setting screen will appear.
Press the [
![]() ![]() ![]() ![]() ![]() ![]() 5. When the icon changes to [
![]() ![]() The flash cannot be configured in the following shooting modes. ![]()
When [Raise the Flash] is Displayed When shooting in [AUTO] mode or [Hybrid Auto] mode in low-light conditions, [Raise the flash] may be displayed on the cameraâs screen. In this case, please move the <
![]() ![]() When the message shown above is displayed, please move the [ ![]() Flash Range If your shots are dark despite the flash firing, move closer to the subject.
See the table below for details on the flash range.
|
||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
ID: 8202799800_EN_2
|
SIMS Doc Id
8202799800