Replacing / Reseating the Print Head - TS6020

 

Description

This article explains how to replace / reseat the print head for your PIXMA TS6020.

 

Solution

If you need to replace or reseat the print head for your PIXMA TS6020 printer, follow the steps below.
  1. With the printer turned on, open the scanning unit / cover.


     
  2. Remove each of the ink tanks by pressing the tab (A) and lifting the ink tanks out of the printer.  Remove the ink tanks one at a time.


     
  3. After all of the ink tanks have been removed, press and hold the Stop button on the printer's operation panel.



    After a few moments, the print head holder will move to the replacement position.


     
  4. On the front of the print head lock lever, grip the left and right sides and lift (outlined in the red box).



    The lock lever will remain in a raised position.


     
  5. Grip the print head by either the left or right side.  Tilt it towards the front of the printer.



    The print head can then be lifted out of the printer.


     
  6. Place the print head back into the printer by inserting it at an angle.  It will then tilt back into the print head holder.  Lower the lock lever until it clicks into place.

 Note
If you are placing a new print head into the printer, be sure to remove it from its packaging and remove any orange packing material on it.
 
  1. Place one of the inks back into the printer.



    After the ink has been reinserted, press down on the front end of the ink tank until it snaps into place and the light turns on.



    Repeat this step for the remaining ink tanks.
     
  2. The printer will then inform you of the inks that have been reinserted.  Tap OK.
     
  3. Print a nozzle check to confirm that the nozzles are functioning properly.

TS6020 Page


 

Doc ID   ART167312
Updated   04/09/2019

Rate this Article
Was this article helpful?
Yes, This document is helpful
No, This document needs a clearer explanation
 
Please provide your comments