Loading Paper in the Rear Tray - TR7520
Article ID: ART168128 | Date published: 07/18/2017 | Date last updated: 09/20/2019
 

Description

This article explains how to load paper in the rear tray of the PIXMA TR7520.

 

Solution

You can load plain paper or photo paper.

You can also load envelopes on the rear tray.


 Important

  • If you cut plain paper into small size such as 4" x 6" (10 x 15 cm) or 5" x 7" (13 x 18 cm) to perform trial print, it can cause paper jams.


 Note

  • We recommend Canon genuine photo paper for printing photos.
    For details on the Canon genuine paper, see Supported Media Types.

     

  • You can use general copy paper or Canon Red Label Superior WOP111/Canon Océ Office Colour Paper SAT213.
    For the page size and paper weight you can use for this printer, see Supported Media Types.

     

  1. Prepare paper.
    Align the edges of paper. If paper is curled, flatten it.



     Note

    • Align the edges of paper neatly before loading. Loading paper without aligning the edges may cause paper jams.
    • If paper is curled, hold the curled corners and gently bend them in the opposite direction until the paper becomes completely flat.

       

  2. Load paper.

    1. Open the rear tray cover (A) and then pull up the paper support (B).



       
    2. Open the feed slot cover (C).



       
    3. Slide the paper guides to open them, and load the paper in the center of the rear tray WITH THE PRINT SIDE FACING UP.
       

    4. Slide the paper guides (D) to align them with both sides of the paper stack.
      Do not slide the paper guides too hard against the paper. The paper may not be fed properly.



       

       Important

      • Always load paper in the portrait orientation (E). Loading paper in the landscape orientation (F) can cause paper jams.



       Note

      • Do not load sheets of paper higher than the load limit mark (G).



         
    5. Close the feed slot cover (H) gently.


       Important

      • If the feed slot cover is open, paper cannot be fed. Be sure to close the feed slot cover.


       

      After closing the feed slot cover, the paper information registration screen for the rear tray is displayed on the touch screen.

    6. Select the size and type of the loaded paper in the rear tray at Page size and Type, and then select Register.



       
    7. Open the operation panel (I), pull out the paper output tray (J) and paper output support (K), and open the output tray extension (L).
      Be sure to open the operation panel before printing. If the operation panel is close, the printer does not start printing.



       


 Note

  • When printing, select the size and type of the loaded paper on the print settings screen of the operation panel or the computer.

    • There are various types of paper, such as paper with a special surface coating for printing photos at optimal quality and paper suitable for documents. Each media type has specific preset settings (how ink is used and sprayed, distance from nozzles, etc.), that allow you to print to that type with optimal image quality. The wrong paper settings may cause poor printout color quality or scratches on the printed surface. If you notice blurring or uneven colors, increase the print quality setting and try printing again.
       
    • To prevent incorrect printing, this printer has a function that detects whether the information set for the paper loaded on the rear tray matches the paper settings. Before printing, make paper settings in accordance with the paper information. When this function is enabled, an error message is displayed if these settings do not match to prevent incorrect printing. When this error message is displayed, check and correct the paper settings.

      If you wish to disable this setting, tap the Settings icon and then tap Settings -> Device settings -> Feed settings -> Detect paper setting mismatch -> No.