When the lens is mounted, connect the cable from the drive unit to a power supply equipment such as the camera or external power supply.

Or if the camera can be powered from the PL mount, connect the cable from the drive unit to the connector below the lens mount.

*Connect the cable so that the connector of the cable aligns with the connector of the lens.

*Bundle up the cable with the tie cable as needed.
 

CINE-SERVO 17-120mm T2.95-3.9 EF/PL (CN7X17)

CINE-SERVO 50-1000mm T5.0-8.9 EF/PL (CN20X50)

 

NOTE Rated voltage: 12 VDC Normal operation range: 10 to 17 VDC If a battery or adapter is used, the output voltage may be higher than the rated voltage depending on the manufacturers and therefore the above voltages must be observed strictly. If a voltage outside the normal operation range is used, the drive unit may be damaged.