Projecting from Multiple Projectors at Once (Edge Blending)

Keep in mind when projecting from multiple projectors that each unit may have a different color balance. Thus, even with the same model, differences in color may be noticeable.

1 Select [Install settings] > [Professional settings] > [Edge blending] > [Adjust].


2 Set [Marker] to [On].
Marker lines are projected on the images. The red marker indicates the start position for adjustment, and the green marker, the end position.
Initially, only the red marker is visible when you prepare for edge blending, because it is projected over the green marker




3 In [Side], select [Start position] and use the buttons to move the start marker to the outer edge of the overlapping area.
Do this for each edge; on the top, bottom, left, and right.






4 Select [Width] and use the buttons to move the end marker to the inner edge of the overlapping area.
Do this for each edge; on the top, bottom, left, and right.




The area between the starting and ending markers is called the blending area.
Shading is applied to this area, and the brightness is adjusted to match portions that overlap with other areas. After you complete settings for one image, do the same thing for the other one to specify the blending area. Adjust the settings to make the blending area for each image the same.

5 Set [Marker] to [Off].