Note　

• Before loading rolls, make sure the printer is clean inside the Top Cover and around the Ejection Guide. If these areas are dirty, we recommend cleaning them in advance.　

1. Press the Load button.　

2. Press ▲ or ▼ to select "Load Roll Paper", and then press the OK button.　

Note　

• If any paper has been advanced that will not be used, a message is shown requesting you to remove it. Press ▲ or ▼ to select Yes, and then press the OK button. Remove the paper and go to the next step.　

3. Positioning your hands as shown, open the Roll Cover.　

Note　

• There is no cover over the roll unit on the iPF670E.　

4. Holding the Roll Holder flange (a), rest the Roll Holder shaft on the Roll Ledge (b). At this time, position the holder so that the R label (c) on the [W label (c) on the Roll Holder flange is aligned with the R label (d) on the printer .　

5. Holding the Roll Holder flange (a), guide the holder along the Roll Loading Slots (b) on both ends, keeping the holder level as you load it in the Roll Holder Slot.　

　
Caution　

• Do not force the Roll Holder into the printer with the right and left ends reversed. This may damage the printer and Roll Holder.　
• Do not release the flanges until the holder is loaded in the Roll Holder Slot.　
• Be careful not to pinch your fingers between the Roll Loading Slots (b) and the Roll Holder shaft (c) when loading rolls.

6. Insert the edge of the roll in the Paper Feed Slot (a) and advance the roll until you hear the feed tone.　

Important　

• Be careful not to soil the printing surface of roll paper as you insert it in the slot. This may affect the printing quality. We recommend wearing clean cloth gloves when handling rolls to protect the printing surface.　
• If the paper is wrinkled or warped, straighten it out before loading it.　
• Load paper straight so it is not fed askew.　
• Make sure there is not a lot of slack in the roll. Too much slack in roll can cause loading issues.　
• Make sure the right edge is lined up correctly with the orange reference line.

7. Once paper feeding starts, you will need to do the following, based on the ManageRemainRoll setting and the barcode printed on rolls.ser's Guide　

Note　

• For details on types of paper to select, see the Paper Reference Guide. 
• iPF670/670E Paper Reference Guide
• iPF770 Paper Reference Guide

User's Guide　

8. Holding it at the positions indicated, close the Roll Cover.

Note　

• There is no cover over the roll unit on the iPF670E.　
• Cut the edge of the roll after the paper is advanced if it is soiled or if there are cuts from scissors or the blade after removing creased edges.
   

9. If you need additional assistance please visit the Troubleshooting Section of the User's Guide.

• imagePROGRAF iPF670/iPF670E
• imagePROGRAF iPF770