Installing Remote Control Batteries REALis 4K6020Z / 4K5020Z

Article ID: ART172828 | Date published: 12/21/2018 | Date last updated: 12/21/2018


Installing Remote Control Batteries  REALis 4K6020Z / 4K5020Z


1 Open the battery
compartment lid.
Slide the lid while pressing
it down.
2 Insert batteries.
Insert 2 new AAA batteries
in the compartment with
the + and – terminals
positioned correctly
3 Close the compartment lid.
Slide the lid until you hear a
click to securely close it.
  • If buttons on the remote control are inoperative when you attempt to operate the projector, replace the batteries with new ones.
  • Do not drop the remote control or subject it to impact.
  • Do not spill any liquids on the remote control. Doing so may cause a malfunction.
Pay attention to the following points when handling the batteries.
Failing to do so could result in a fire or personal injury.
• Do not heat, short circuit or disassemble the batteries, or place
them in a fire.
• Do not attempt to recharge the batteries that are included with the
remote control.
• Remove the batteries when they are flat or when the remote
control will not be used for a long period of time.
• When replacing the batteries, replace both at the same time. Also,
do not use two batteries of a different type at the same time.
• Insert the batteries with the + and – terminals in the correct
• If any liquid from inside the batteries leaks out and contacts your
skin, be sure to wash the liquid off thoroughly.

Rate this Article
Was this article helpful?
Yes, This document is helpful
No, This document needs a clearer explanation
Please provide your comments