Manual Adjustment to Correct Registration REALis 4K6020Z / 4K5020Z
Article ID: ART172857 | Date published: 12/21/2018 | Date last updated: 12/21/2018
 

Description

Manual Adjustment to Correct Registration  REALis 4K6020Z / 4K5020Z

Solution

Manual Registration
Use manual adjustment to correct registration only in certain areas
Any manual adjustment values set before switching to 5-point adjustment are cleared.

1 In the [Install settings] menu, select [Professional settings] > [RGB alignment] > [Advanced registration] > [Adjust] > [Manual adjustment].
The projector enters manual adjustment mode, and a chart is displayed.


With advanced registration, checkered or halftone image areas may be affected by uneven colors or image artifacts.

2 Use the buttons to select the point for correction, and then press the OK button.
The projector enters color selection mode.

Press the MENU button to return to [Advanced registration].

3 Select [Red], [Green], or [Blue] as the color, and then press the OK button.
  • Each time you select [Chart] and press the OK button, display switches between the chart and the source signal.
  • Accessing the manual adjustment window during test pattern projection will show the test pattern instead of your supplied signal
4 Use the buttons to align the adjustment points.

5 Press the OK button to return to the window for color selection mode.
6 Repeat this process to align the remaining colors and adjustment points.


Resetting Image Registration
Clears the values set in 5-point adjustment or manual adjustment.

1 In the [Install settings] menu, select [Professional settings] > [RGB alignment] > [Advanced registration] > [Adjust] > [Reset].
A confirmation message for resetting is displayed.

2 Select [OK] to reset the adjustment.
The following tasks are executed.
  • Values set in 5-point adjustment are cleared.
  • 5-point adjustment is deactivated.
  • Values set in manual adjustment are cleared.
[Advanced registration] setting values are not cleared if you switch lenses. However, on
startup after you switch lenses, a message is displayed requesting you to confirm advanced
registration settings if, for any adjustment point, [Advanced registration] setting values differ
from defaults.