Menu Description Power supply settings REALis 4K6020Z / 4K5020Z

Article ID: ART172877 | Date published: 12/24/2018 | Date last updated: 12/24/2018


Menu Description Power supply settings   REALis 4K6020Z / 4K5020Z


Power supply settings
> [System settings] > [Power supply settings]
Specify how power is managed at startup, in standby, and when no signal is supplied.

Standby power setting
Specify network function operating status in standby mode.
  • [Standby power setting] is set to [Normal] and cannot be changed when scheduling is enabled 
  • [Standby power setting] is set to [Normal] and cannot be changed when wireless LAN is enabled 

Quick startup
Enable faster startup next time by leaving some circuits on for 90 minutes after the projector is turned off. However, to avoid sudden surges in intensity, projection is delayed by at least approximately 1.7 seconds.

Power management mode
Specify to turn the light source off or enter standby if there is no input signal. This feature automatically turns off the light source or power after a certain period if the remote control or projector is not operated.
  • Projection resumes when the same input signal is restored, when the remote control or projector is operated, or when user commands are sent to turn the projector on.
  • After the projector enters standby, restoring projection requires the same steps as when turning the projector on normally.
  • When [Disabled] is selected, [Direct power on] is not available.

Power management duration
Specify how much time must pass before the light source goes off or the projector enters standby mode, depending on the [Power management mode] setting.
  • Can be set to 5 min., 10 min., 15 min., 20 min., 30 min., or 60 min.
  • If conditions that would start countdown are met while you are blanking projection, blanking is canceled.
Direct power on
You can turn on the projector by connecting the power cable without pressing the POWER button.
  • Before enabling direct power on, be sure to set [Power management mode] to an option other than [Disabled]. When [Disabled] is selected, [Direct power on] is not available.
  • The projector is also equipped with a Direct Power Off feature. No damage is caused to the projector even if it is unplugged during projection to turn it off without pressing the POWER button. However, setting adjustments made immediately before unplugging the projector may not be stored.

Rate this Article
Was this article helpful?
Yes, This document is helpful
No, This document needs a clearer explanation
Please provide your comments