Troubleshooting LX-MH502Z
| Article ID: ART172951 |
| |
Date published: 12/28/2018 |
| |
Date last updated: 12/28/2018 |
Description
Troubleshooting LX-MH502Z
Solution
The projector does not turn on.
| Cause |
Remedy |
There is no power from the power cord. |
Plug the power cord into the AC power jack on the
projector, and plug the power cord into the power outlet. If the power outlet has a switch, make sure that it is switched on. |
Attempting to turn the projector on again
during the cooling process. |
Wait until the cooling down process has
completed. |
No picture
| Cause |
Remedy |
The video source is not turned on or
connected correctly. |
Turn the video source on and check that the signal
cable is connected correctly. |
The projector is not correctly connected to
the input signal device. |
Check the connection. |
The input signal has not been correctly
selected. |
Select the correct input signal with the INPUT key. |
Blurred image
| Cause |
Remedy |
The projection lens is not correctly
focused. |
Adjust the focus of the lens using the focus ring. |
Depending on video signal timing, the
projector needs to fine-tune for less blurred
image. |
Adjust Phase in the DISPLAY menu. |
Remote control does not work.
| Cause |
Remedy |
| The battery is out of power. |
Replace the battery with new one. |
There is an obstacle between the remote
control and the projector. |
Remove the obstacle. |
| You are too far away from the projector. |
Stand within 8 meters (26 feet) of the IR remote
sensor. |
The password is incorrect.
| Cause |
Remedy |
| You do not remember the password. |
See "Security Settings" |
Web page does not appear in web browser.
| Cause |
Remedy |
| LAN control settings or LAN cable connection are problematic. |
Verify the LAN control settings. Please see
"Network Settings" for details. Make sure the LAN cables are properly connected. |
The projector's network settings are not
reflected, or the IP address of the projector entered in the browser's address bar is wrong. |
Please reload the web page in the browser.
If you do not see it even after updating the web page, please check the IP address of the projector. |
