Ask a Question

Connecting Your Printer to a Wireless LAN (WPS PIN Code) - G3200

Article ID: ART173505 | Date published: 01/18/2019 | Date last updated: 01/18/2019
 

Description

This article shows how to start a wireless connection of your PIXMA G3200 to a wireless LAN using the WPS PIN code method.

 

Solution

To connect your PIXMA G3200 to a wireless router using the WPS PIN code method, please follow the steps below.
 

  1. Load two sheets of A4 or Letter-sized plain paper.
     

  2. Press and hold the Wi-Fi button (A) on the printer until the ON lamp (B) flashes.



     

  3. Press the Wi-Fi button.

    The Network Configuration Page including the PIN code will be printed.  An example of this page is attached to this article.



     

  4. Press and hold the Stop button (C) on the printer until the Alarm lamp flashes 20 times, and then release the Stop button after the twentieth flash.


    figure: Press and hold the Stop button and the Alarm lamp flashes 20 times
     

  5. Follow the on-screen instructions on the device (such as a smartphone) to set the WPS PIN CODE described on the printed Network Configuration Page to the wireless router.
     

  6. Make sure the Wi-Fi lamp (D) on the printer is lit.




     

Attachment

G3200_nw_conf.pdf
60K • < 1 minute @ 56k, < 1 minute @ broadband



Rate this Article
Was this article helpful?
Yes, This document is helpful
No, This document needs a clearer explanation
 
Please provide your comments