If you want to change some of the print settings used by the PIXMA MX922 via the operation panel, follow these steps.
- Press the MENU
button.
- Use the arrows to select Setup, then press the OK button.
- Use the arrows to select Device settings, then press the OK button.
- Use the arrows to highlight Print settings, then press the OK button.
The settings that can be adjusted are as follows:
- Prevent paper abrasion
Use this setting only if the print surface becomes smudged.
Important
- Be sure to set this back to OFF after printing since it may result in lower printing speed or lower print quality.
- Extended copy amount
Selects the amount of image that extends off the paper when printing in borderless (full).
Slight cropping may occur at the edges since the copied image is enlarged to fill the whole page. You can change the width to be cropped from the borders of the original image as needed.
Cropped area will be larger if Extended amount: Large is selected.
Important
- This setting can be applied under the following conditions:
- performing borderless copying
- Borderless is selected for Border when copying printed photos
Note
- If printouts contain margins even though you are printing in Borderless, specifying Extended amount: Large for this setting may help solve the problem.
-
Adjust disc print area
You can adjust the disc printing area if the image is not aligned with the printable disc.
You can adjust the printing area by 0.003 inches/0.1 mm between -0.03 inches/-0.9 mm and +0.03 inches/+0.9 mm.
-
Auto photo fix setting
When ON is selected, you can select whether to print photos using the Exif information recorded in the image files in the following cases.
-
Auto photo fix is selected for Photo fix when printing from a USB flash drive.
-
When Auto photo fix is selected for Photo fix in printing a photo in online photo album.
-
The print setting on the PictBridge compliant device is set to Default* or On when printing with a PictBridge compliant device.
* When Default is selected for the print setting on the PictBridge compliant device, select Auto photo fix for Photo fix in PictBridge print settings.
