Ask a Question

Installing and removing the battery on the EOS 5D Mark II.

Article ID: ART174039 | Date published: 04/24/2019 | Date last updated: 04/24/2019
 

Description

Installing and removing the battery on the EOS 5D Mark II.

Solution

Installing the battery.
Load a fully charged Battery Pack LP-E6 into the camera.

1. Open the battery compartment cover.

  • Slide the lever as shown by the arrow and open the cover.

2. Insert the battery.

  • Insert the end with the battery contacts.
  • Insert the battery until it locks in place.

3. Close the cover.

  • Press the cover until it snaps shut.
  Only the Battery Pack LP-E6 can be used.
 
Removing the battery

Open the cover and remove the battery.

  • Press the battery release lever as shown by the arrow and remove the battery.
  • To prevent short circuiting, be sure to attach the protective cover to the battery.
  After opening the battery compartment cover, be careful not to swing it back further. Otherwise, the hinge might break.

Rate this Article
Was this article helpful?
Yes, This document is helpful
No, This document needs a clearer explanation
 
Please provide your comments