Inserting and removing the card and battery on the EOS RP
Article ID: ART174127
|
Date published: 04/29/2019
|
Date last updated: 06/07/2019
Description
Inserting and removing the card and battery on the EOS RP
Solution
Insert a fully charged Battery Pack LP-E17 into the camera. The camera can use SD, SDHC, or SDXC memory cards (sold separately). UHS-II/UHS-I SDHC and SDXC cards are also supported. The captured images are recorded onto the card.
Insertion
1. Slide the card slot/battery compartment cover lock and open the cover.
2. Insert the battery.
Insert the end with the electrical contacts.
Insert the battery until it locks in place.
3. Insert the card.
Insert the card with the label facing the back of the camera as shown until it clicks in place.
4. Close the cover.
Press the cover until it snaps shut.
Removal
1. Open the card slot/battery compartment cover.
Set the power switch to <OFF>.
Check that the access lamp (1) is off, then open the cover.
If [Saving...] is diaplayed on the screen, close the cover.
2. Remove the battery.
Press the battery lock lever as shown by the arrow and remove the battery.
To prevent short-circuits, always attach the included protective cover to the battery.
