Installing and removing the card and battery on the EOS Rebel T3
Article ID: ART174154
|
Date published: 04/29/2019
|
Date last updated: 04/29/2019
Description
Installing and removing the card and battery on the EOS Rebel T3
Solution
Load a fully charged Battery Pack LP-E10 into the camera. The card (sold separately) can be an SD, SDHC, or SDXC memory card. The captured images are recorded onto the card.
Installing the battery and card
1. Open the cover.
Slide the lever as shown by the arrows and open the cover.
2. Insert the battery.
Insert the end with the battery contacts.
Insert the battery until it locks in place.
3. Insert the card.
As shown by the illustration, face the card's label side toward the back of the camera and insert it until it clicks in place.
Insert the card straight in all the way.
4. Close the cover.
Press the cover until it snaps shut.
When you set the power switch to <ON>, the number of possible shots will be displayed on the LCD monitor.
Removing the battery and card
1. Set the power switch to <OFF>.
2. Open the cover.
Make sure the access lamp is off, then open the cover.
If [Recording...] is displayed, close the cover.
3. Remove the battery.
Press the battery lock lever as shown by the arrow and remove the battery.
To prevent short circuiting of the battery contacts, be sure to attach the provided protective cover to the battery.
4. Remove the card.
Gently push in the card, then let it go to eject it.
