Replacing the Lamp
When the time of use of the lamp exceeds the certain amount of time, the following message (two types) is displayed for 10 seconds every time the projector is turned on.
| 1,8000 - less than 2,000 hours |
 |
Prepare the new lamp when this screen is displayed.
- Only [<], [>], the OK button, and the POWER button are available while this screen is displayed.
- When you press the POWER button, "Push POWER button again to turn off power." message appears.
|
- After this screen has been displayed for 10 seconds and disappeared, all buttons become operable.
- This message will not be displayed again if you select [Cancel] in response to the message "Do you want to display this message again?"
| Over 2,000 hours |
 |
Replace the lamp by referring to the procedure below when this screen is displayed.
- Only the POWER button is available while this screen is displayed.
- When you press the POWER button, "Push POWER button again to turn off power." message appears.
|
- After this screen has been displayed for 10 seconds and disappeared, all buttons become operable.
- You can check the time of use of the lamp in [Lamp counter] in the [System settings] menu.
About the Replacing Lamp
This projector uses the following lamp.
Lamp type No.RS-LP04 |
 |
- Be sure to use the specified lamp.
- A lamp can be ordered from your dealer.
- When replacing the lamp, turn off the projector, wait until the cooling fan stops, disconnect the power plug from the AC outlet, and let the projector stand for at least 1 hour. Otherwise, you may get burned because the main unit is very hot immediately after the projector is turned off.
- Do not touch the inner glass surface when you replace the lamp. Otherwise, the projector's performance may degrade.
- Make sure to handle the lamp carefully and correctly since it may explode if it is scratched or shocked. If a lamp explodes, follow the instructions under "If a Lamp Explodes" on page 17 of the WUX10 Mark II manual.
- Do not remove screws unless specified.
|
Replacing the Lamp
1.
|
Turn off the projector, disconnect the power plug from the AC outlet, and let the projector stand for at least 1 hour.
|
 |
2.
|
Loosen a screw with a flathead screwdriver and remove the lamp cover.
|
3.
|
Loosen two screws, pull up the handle, and then remove the lamp.
|
|
4.
|
Fully insert a new lamp and secure it with two screws.
* After the installation, be sure to push down the handle. |
 |
5.
|
Replace the lamp cover and tighten the screw.
|
6.
|
Turn on the projector.
|
 |
7.
|
Bring up the menu and select [System settings] --> [Other settings] --> [Lamp counter].
|
8.
|
Select [Reset] --> [OK] to reset the lamp counter.
|
