Charging the battery for the EOS Rebel T100
| Article ID: ART176493 |
| |
Date published: 02/05/2020 |
| |
Date last updated: 02/05/2020 |
Description
Please see below for instructions on charging the LP-E10 battery pack.
Solution
Charging the Battery
 |
 |
Remove the protective cover. |
 |
Detach the protective cover provided with the battery. |
 |
 |
Attach the battery. |
|
As shown in the illustration, attach the battery securely to the charger. |
|
To detach the battery, follow the above procedure in reverse. |
 |
 |
Recharge the battery.
For LC-E10 |
|
As shown by the arrow, flip out the battery charger's prongs and insert the prongs into a power outlet. |
| For LC-E10E |
|
Connect the power cord to the charger and insert the plug into a power outlet. |
 |
Recharging starts and the charge lamp lights up in orange |
|
When the battery is fully recharged, the full-charge lamp will light up in green. |
- It takes approx. 2 hours to fully recharge a completely exhausted battery at room temperature (23°C / 73°F). The time required to recharge the battery will vary greatly depending on the ambient temperature and the battery's remaining capacity.
- For safety reason's, recharging in low tempertures (6°C - 10°C / 43°F - 50°F) will take longer (up to approx. 4 hours).
|
| |
 Tips for Using the Battery and Charger
|
 |
Upon purchase, the battery is not fully charged.
Charge the battery before use. |
|
Recharge the battery on the day before or on the day it is to be used.
Even during storage, a charged battery will gradually drain and lose its capacity. |
|
After recharging the battery, detach it and disconnect the charger from the power outlet. |
|
When not using the camera, remove the battery.
If the battery is left in the camera for a prolonged period, a small amount of power current is released, resulting in excessa discharge and shorter battery life. Store the battery with the protective cover (provided) attached. Storing the battery when it is fully charged may lower the battery's performance. |
|
The battery charger can also be used in foreign countries.
The battery charger is compatible with a 100 V AC to 240 V AC 50/60 Hz power source. If necessary, attach a commercially-available plug adapter for the respective country or region. Do not attach any portable voltage transformer to the battery charger. Doing so can damage the battery charger. |
|
If the battery becomes exhausted quickly even after being fully charged, the battery has reached the end of its service life.
Purchase a new battery. |
| |
|
 |
|
After disconnecting the charger's power plug, do not touch the prongs for at least 3 sec. |
| |
|
Do not charge any battery other than a Battery Pack LP-E10. |
| |
|
Battery Pack LP-E10 is dedicated to CAnon products only. Using it with an incompatible battery charger or product may result in malfunction or accidents for which Canon cannot be held liable. |
