➤
Ask a Question

EOS REBEL T8i: Sensor Cleaning

Article ID: ART177049 | Date published: 06/19/2020 | Date last updated: 09/15/2023
 

Description

Sensor Cleaning

Solution

 

Sensor Cleaning

Cleaning Now

  1. Select [Set-up: Sensor cleaning].

  2. Select [Clean now].

    • Select [OK] on the confirmation screen.

Cleaning Automatically

  1. Select [Auto cleaning].

  2. Select a setting item.

    • Use the Left key Right key keys to select an item, then press SET.

Note

  • For best results, clean with the camera in a stable position on a desk or other flat surface.
  • Even if you repeat the sensor cleaning, the result will not improve much. Note that [Clean now] may not be available immediately after cleaning.
  • Dots of light may appear in captured images or on the shooting screen if the sensor is affected by cosmic rays or similar factors. By selecting [Clean now], their appearance may be suppressed ().

Cleaning Manually

Dust that could not be removed by automatic cleaning can be removed manually with a commercially available blower or similar tool.

Always use a fully charged battery.

The image sensor is extremely delicate. If the sensor needs to be cleaned directly, having it done by a Canon Service Center is recommended.

  1. Select [Set-up: Sensor cleaning].

  2. Select [Clean manually].

  3. Select [OK].

  4. Remove the lens and clean the sensor.

  5. End the cleaning.

    • Set the power switch to Power off.

Note

  • Using the household power outlet accessories (sold separately) is recommended.

Caution

  • While cleaning the sensor, never do any of the following. If the power is cut off, the shutter will close and the reflex mirror will go back down. These may result in damaging the image sensor, shutter curtains, and reflex mirror.

    • Setting the power switch to Power off.
    • Removing or inserting the battery.
  • The surface of the image sensor is extremely delicate. Clean the sensor with care.
  • Use a plain blower without any brush attached. A brush can scratch the sensor.
  • Do not insert the blower tip inside the camera beyond the lens mount. If the power is turned off, the shutter will close and the shutter curtains or reflex mirror may get damaged.
  • Never use pressurized air or gas to clean the sensor. Pressurized air may damage the sensor, and sprayed gas may freeze on the sensor and scratch it.
  • If the battery level becomes low while cleaning the sensor, the beeper will sound as a warning. Stop cleaning the sensor.
  • If a smudge that cannot be removed with a blower remains, having the sensor cleaned by a Canon Service Center is recommended.
 

 

SIMS Doc Id

1592433366

Rate this Article
Was this article helpful?
Yes, This document is helpful
No, This document needs a clearer explanation
 
Please provide your comments