Removing Printable Nail Stickers - PRO-300

Article ID: ART177142 | Date published: 07/20/2020 | Date last updated: 07/27/2020


Learn about removing Printable Nail Stickers from the multi-purpose tray of the imagePROGRAF PRO-300.


Removing Printable Nail Stickers

  1. Pull out the multi-purpose tray.

    Figure: Pull out the multi-purpose tray
  2. Close the multi-purpose tray guide.

     If the multi-purpose tray guide is opened, you cannot print on paper as it will not feed properly. Make sure that the multi-purpose tray guide is closed.

    Figure: Close the multi-purpose tray guide

  3. Remove Printable Nail Stickers.

    While pressing down lock (A), remove two tabs (B) on the top out of slits (C).

     Do not touch the printing surface when removing Printable Nail Stickers.

     Allow the printing surface to dry before removing Printable Nail Stickers. If you see printing on the multi-purpose tray or outside the Printable Nail Stickers, wipe them clean after the printing surface has dried.

    Figure: While pressing down the lock (A), remove the two tabs (B) on the top out of the slits (C).
  4. Peel a sheet of Printable Nail Stickers from the adapter.

     Allow the printing surface to dry before tearing off Printable Nail Stickers from its edges.

    Figure: Peel a sheet of Printable Nail Stickers from the adapter
  5. Insert the multi-purpose tray straight into the multi-purpose tray storage compartment.

    When not using the multi-purpose tray, insert it in the multi-purpose tray storage compartment.

If your product issue was not resolved after following the steps above, or if you require additional help, please create or log in to your Canon Account to see your technical support options.

Or if you still need help, visit our Canon Community by clicking the button below to get answers:

Link to Canon Community Forum


Rate this Article
Was this article helpful?
Yes, This document is helpful
No, This document needs a clearer explanation
Please provide your comments