Before Printing on Art Paper - PRO-300

Article ID: ART177237 | Date published: 07/29/2020 | Date last updated: 07/29/2020


This article contains important information you need to know before using the imagePROGRAF PRO-300 to print on art paper.


Before Printing on Art Paper

When using art paper, dust is liable to be generated. It is therefore recommended that paper dust be removed on art paper just before printing.

You will need a soft hair brush (or similar brush used to clean office automation equipment).

The wider the brush, the more effective it will be.

A wider brush will be more effective

OK - soft brush made from material such as polypropylene, polyethylene, horse hair or goat hair.

 Be sure not to use brushes as shown below. The printing surface may be damaged.

Don't use brushes like these

Not OK - brush made from hard material, cloth or washcloth, sticky and abrasive materials.

Paper dust removal procedure:

  1. Check that the brush is not wet and free from dust or dirt.

  2. Brush the overall printing surface carefully in one direction.

    Brush the surface in one direction (left to right shown in the image)

     Be sure to brush all the way across the paper; do not start brushing at the middle or stop halfway.

     Be careful not to touch the printing surface as much as possible.

  3. To complete the removal of paper dust, brush the paper in the other direction from top to bottom.

    Brush from top to bottom

If your product issue was not resolved after following the steps above, or if you require additional help, please create or log in to your Canon Account to see your technical support options.

Rate this Article
Was this article helpful?
Yes, This document is helpful
No, This document needs a clearer explanation
Please provide your comments