Changing the printing speed
It is possible to change the printing speed. However, if the printing speed is too fast for the environment in which the printer is used and the characteristics of the print media, printing may shift out of position or be otherwise affected. The print speed can be set to one of three levels: Low*, Middle*, or High*.
*When Low is selected, characters can be printed on 30 tube segments / min. When Middle is selected, characters can be printed on 35 tube segments / min. When High is selected, characters can be printed on 40 tube segments / min. (The segment length is 20 mm, five 3mm 100% characters are entered, and each tube is cut into two segments. This feature is available only for printing on tube.)
If the characters printed at a temperature below 20 degrees C with High selected on the Print speed selection display are faint, select a lower printing speed.
ex. Set the print speed to Low.
-
Press [Func].
|
|
-
Press  or  to select Print speed, then press [Enter].
|
|
-
Press or to select Low, then press [Enter].
|
If L is displayed, the print speed has been set to Low. M and H are displayed for Middle and High, respectively.
|
Printing speed
You can select a printing speed from among low speed, middle speed, and high speed. The actual printing speed varies depending on the media type. The print speeds are measured in mm / sec.
|
Printing media
|
Printing speed
|
Cut
|
Not cut
|
|
Tube
Clear tube
|
Low
|
18.5
|
|
Middle
|
25
|
20
|
|
High
|
40
|
|
Heat-shrinkable tube
4 mm I.D. strip
Label
Wraparound tape
|
Low
Middle
|
25
|
20
|
|
High
|
40
|
|
Plate
|
Low
Middle
|
Cannot be cut.
|
18.5
|
|
High
|
40
|
If your product issue was not resolved after following the steps above, or if you require additional help, please create or log in to your Canon Account to see your technical support options.
Or if you still need help, visit our Canon Community by clicking the button below to get answers:
____________________________________________________________________________________________
