Depending on your print media and the environment, the print position may be shifted or cut length may be different from the setting. If you cannot get the result you expected even after setting the cut length and margins, fine-tune the print position and cut length.

For this product, the following adjustments can be set for each type of print media (for vertical adjust, by type and by size).

 If the situation is not improved by adjusting the adjustment function, clean the transport roller.

Also, make sure that there is no dirt on the print media.

Fine-tuning of the Print Start Position (Top Adjust)

[Example] When printing on a tube in the "Centered" position, the text is shifted to the left, so move the print start position 2.0 mm to the right.

Fine-tuning the Print Position in the Vertical Direction (Vertical Adjust)

[Example] When printing on a tube (ø6.0 mm), the print position is shifted upward, so move the print position downward by 0.5 mm.

Fine-tuning the Cut Length (Length Adjust)

[Example] When printing on a tube with a cut length of "30 mm," the tube is printed shorter than the setting, so the cut length is increased by 2 mm.

 No further adjust in the negative direction will be applied when there is no more space for adjust (other than characters) or when the minimum cut length or less is reached.

 If the problem is not corrected by using the length adjust, set the half cut to "None" and cut with scissors.

Depending on the print media you are using and the environment, the printing may be too light or too dark. In such cases, adjust the print density.

The density can be set for each print media. The default setting is "3."
 

[Example] Adjust the print density of the tube so that it is the darkest.

If printing is blurred or uneven, adjust the print speed.

The default setting is "High."
 

[Example] Setting the speed to "Low" because the text is blurred.